  |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
How to Specify a Load Case Multiplier for Heat FluxWhen applying a heat flux load for a steady-state or transient heat transfer analysis, a load case multiplier must be input into the "Analysis Parameters" screen. A "Convection multiplier" of "1" will activate applied heat flux loads, as shown below.
Figure 1: Specifying the convection multiplier on the "Analysis Parameters" screen. For more information about specifying a heat flux load, see the ALGOR User's Guide. |
 |
 |
|
 |
|
 |
|
 |
|
 |
|
 |